The pipe bending machine is a new type of pipe bending tool with a curved pipe function and a topping function. It has many advantages such as reasonable structure, safe use, convenient operation, reasonable price, fast loading and unloading, easy to carry, multi-purpose, etc. It has a large share in the domestic hydraulic market, mainly used in factories, warehouses, docks, buildings, railways and automobiles. Wait for the installation of pipes and repairs. In addition to the elbow function, it can also be used to remove the elbow parts as a separate hydraulic overhead machine.
Then, when purchasing back, pay attention to the following points when using:
1. Before operation, please check whether the lubrication points of the machine are lack of oil, whether the safety protection device is reliable, whether the movement mechanism is loose, etc.
2. Start the oil pump and check whether the system pressure is within the specified range. If it is high, it will damage the hydraulic components and waste power. If it is too low, it will affect the work.
3. Adjust the position and required angle of the part and position the part to the required length.
4. Adjust the vertical lifting rail to make the guiding mold pressing cylinder advance to clamp the tight iron pipe.
5. The clamping mold clamping cylinder can clamp the iron pipe.
6. Normal operation Put the workpiece into the bending mold, and the front end is in contact with the positioning, and the foot switch can be stepped on.
7. After the work is finished, cut off the power supply and do the cleaning and lubrication work.
8. In case of emergency, press the emergency stop button, then turn the twist switch to the manual position and use manual reset. If the fault occurs, please report it in time.
Let's talk about eight methods for tube maintenance:
One: When operating, it must be operated in strict accordance with the operating regulations (emphasis).
Two: The tube bending machine must be kept clean, and the unpainted parts should be coated with anti-rust grease.
Three: Before each start-up, according to the lubrication chart, the lubricant should be added regularly, fixed point and quantitatively. The oil should be clean and free of sediment.
Four: Regularly check the repair switch, insurance, handle, to ensure that its work is reliable.
Five: The lubricant in the motor bearing should be replaced regularly, and often check whether the motor part is working properly.
Six: Regularly check whether the V-belt, handle, knob, and button are damaged. If the wear is serious, replace it in time.
Seven: It is strictly forbidden for non-designated personnel to operate the equipment. It is usually necessary to stop the person from leaving the machine.
Eight: 10 minutes before leaving work every day, the pipe bending machine is lubricated and cleaned.
Finally, the experts and experts said that in addition to the function of bending, the cylinder in the elbow part can be removed as a separate hydraulic topping machine. Generally, it has good anti-emulsification performance and good anti-foaming performance. Lubricating oil with good performance.
